| TRIBUTE 160: Tanning Booth |
|
The Tribute tanning booth joins our well known vertical tanning line-up.
Like all of its predecessors, this unit is built to last. Made of solid steel,
this unit scores high marks in strength and durability. The unique design will
fit in tight spaces and still provides an attractive front door design.
Recommended room size is 6’ x 7”.
|
 |
Specifications for
Model Tribute 12 minute or 15 minute:
|
36 Rave 100R Plus 100 watt lamp system – 15 minute session
36 Rave 160R Plus 160 watt lamp system – 12 minute session
36 Heartland Rave 10071 R Plus 100 watt lamps
T-Max timer on board (T-Max wireless compatible)
1800 CFM fan on top for body and lamp cooling
*40-50 AMP single phase, 220 – 240 volt with ground required
(for optimum performance, running voltage should be 230 – 240)
*32 AMPS initial start up, 24 AMPS running at 220 VAC
1.0 KVA Buck/Boost transformer may be required if outside 220 – 240 VAC
6’ X 7’ minimum room size required
1 Ton (12,000 BTU) minimum A/C dedicated into room
Shipping weight: 775lbs.
Dimensions: 38”W X 61”D X 88”H
5 Year Limited Warranty
|
|
|
|
Type B seal tight connector supplied. Located on top rear of booth. Type B flexible conduit required.
*Actual amp reading will vary depending on voltage-electrician must calculate load/line side amps
when using a Buck/Boost transformer to insure proper wire gauge and breaker size. Minimum
6 gauge wire size is recommended for this 40 amp circuit to allow less than 2% voltage drop up to 120 feet.
Licensed electrician must refer to National Electric Codes when determining proper wire gauge and breaker
size for each application. All specifications are subject to change.
|
|
